The DTDS’s 622 Module is built based on SEMTECH® SX1262 LoRa® based communications device controlled by RENESAS RL78 G13 family microcontroller running the LoRaWAN® stack. The module is easily interfaceable to a host controller over AT commands.
DTDS’s 622 Module for LoRa® communications

Features:
- Supports LoRaWAN Class A, Class B and Class C
- TCXO enabled stable clock.
- Antenna matching network for a 50 Ohms termination is provided as a part of the module.
- Operating Temperature range -40 deg C to +85 deg C
FCC CERTIFIED
Technical Specifications:
Parameters | Typical Specifications | Units | |
Mechanical
Specification |
Size | 15(W) X 27(L) X 3.0(H) | mm |
Package | 26 pins, SMD | – | |
Electrical
Specification |
Power Supply | +2.4 to +3.6 | V |
Standby Current | < 4 | mA | |
TX Current | 120 mA @22 dBm, 868/915 MHz | mA | |
RX Current | <7 mA @BW 125 kHz, 868/915 MHz | mA | |
Programmable Data Rate | 0.018 to 62.5 (LoRa), 0.6 to 300 (FSK) , 0.3 to 5.0 (LoRaWAN) | Kb/s | |
RF Interface | RFIO single ended, 50 ohm | – | |
Programmable Operating frequency | 863 to 870 (Band 868) | MHz | |
902 to 928 (Band 915) | MHz | ||
RF Specification | Frequency deviation | 0.6 to 200 KHz for FSK | KHz |
Not Programmable in LoRa | |||
Sensitivity | -137dBm @SF12, BW 125kHz | dBm | |
-124dBm @SF7, BW 125kHz | dBm | ||
RF interface | RFIO (UFL connector) | – | |
Interfaces | UART | UART_TX, UART_RX – for AT commands | – |
I2C | I2C_SCL, I2C_SDA | ||
ADC | 10 bit, 2 channels | – | |
GPIO | 2 | ||
Host interface available via AT commands over UART |